LED control is possible to include in a costumer specific variant.
Last Update: August 8, 2017
December 13, 2016 2114 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] Maybe you have some documents or test reports about the influence of the data rate to the range in the same system?
- [RC232] “Please confirm that: RC1180/1140 and 1190 have exactly the same foot print/pin out… The goal being to have only one PCB and the same print for the 3 modules. “
- [RC232] “When I connect to the development board using your software (“”RC232 Configuration and Communication Tool””), everything works fine. But when I connect to the development board from inside my own application for the first time each day (e.g. in the morning when the dev. boards have been powered down for a couple of hours), it only sends 0x00s via the air interface, no matter what i want to send, everything is zero. When I then connect to the board once with your software, everything works fine again and also my application afterwards works fine, and I can send everything correctly again. But I have to do this every morning again. Maybe you have any ideas what the reason for this is or what I could do to fix this problem? “