The RC1240 is compliant with receiver category 1.5.
Last Update: July 21, 2017
July 21, 2017 1841 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “
- [RC232] If more than node will transmit at same to central point – will RC232 protocol queue data somehow, or there will be collision or data will be lost? “
- [RC232] Does your module comply with CE, WPC, FCC and ARIB?