The document you need is the KNX User Manual available from our web after register and signing in.
Last Update: November 9, 2017
November 9, 2017 3267 KNX Q&A
Related Knowledge Base Posts -
- [KNX] Is it possible to configure KNX2 to control a roller shutter via RF just like the remote RF control?
- [KNX] “Recently we have purchased the RC1180DK KNX2 demonstration kit from you. However, we have been unable to get it working. The boards are not transmitting/receiving messages. I have tried using the DEMO application to send packets using the KNX packet generator, while the other board is used as KNX packet sniffer. But nothing shows in the sniffer. Thereafter, I checked the configuration memory and it contains mostly 0x00 and 0xFF. See also attached file (configuration_knx2.txt). Then I loaded the factory settings using the load factory settings in the KNX-CCT tool, but the program gives me an exception error at the end. I am also not able to load settings with the program then. See attached file configuration_knx2_default.txt for the default settings that are loaded. The default settings does not seem to match the ones mentioned in the KNX user manual. Do you have an idea what the problem is and how we can get the transmission working? “
- [KNX] “If i need more 50 device RF (for example), what do I i do to not have problem with a signals?? Can i link a specifics devices of any installation on 1 module RF but not in 2nd RF knx (two rf-knx device installed in same place)? If i need more 50 device RF (for example) how i do to not have problem with a signals?? “