RC1170-MBUS3 and RC1170-MPC1 is made for compliance with Indian regulations.
Last Update: August 8, 2017
December 13, 2016 3828 Wireless M-Bus Q&A
Related Knowledge Base Posts -
- [W-MBUS] “In your mbus manual wrote (pag 4): “”In OMS (MBUS3) the master sends a command with its own address as Link Layer Address, and the slaves address as Application Layer Address.”” You mean that only long Appl header (12 byte) containing the slave address is granted ? If I got it the MUC and slaves have same link address (i.e MUC address) .. is it correct? Does your mailbox feature use this format ? “
- [W-MBUS] What is Wireless M-Bus?
- [W-MBUS] “I configured the MBUS radio to use the UART flow control using the CTS/RTS pins. When the host processor wants to send an MBUS message, it pulls the RTS pin low and waits for the radio to pull CTS up. The processor then sends the message. But this gives strange results, and sometimes it just fails to send the message. I also tried using only the CTS pin, where I wait for the pin to go high before sending the message. Again, this does not always work. Are the CTS/RTS pins exclusively for controlling the flow over the uart connection (host processor to radio) or are they meant to indicate when the radio can send another message ? If so, how should I use them ? “