Skip to content Skip to content

Radiocrafts is Hiring!
PCN Sign Up
Newsletter Sign Up
Log In
Register
My Profile
LinkedIn
YouTube
Facebook
GitHub

Home
Products
Services
- Design Services
- Partners
Applications
Technologies
- Protocols
- Technology Features
News
Resources
Support
About
Distributors
Contact

Home
Products
Services
- Design Services
- Partners
Applications
Technologies
- Protocols
- Technology Features
News
Resources
Support
About
Distributors
Contact

[RC232] Can a channel scan feature be added?

This can be added or you can use the UART command and check channels for RSSI by your host controller.

Last Update: August 8, 2017

December 13, 2016 1820 RC232 Q&A

Related Knowledge Base Posts -

[RC232] I discover that when I start the system, CONFIG pin is low and UART is not initialised. I think it is a mistake and can create some problems. Can you comfirm?
[RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “
[RC232] Where do I read the product ID + min. HW revision + FW revision?

Radiocrafts is a part of LumenRadio

© Copyright 2003-2024 Radiocrafts AS. Sandakerveien 64, NO-0484, OSLO, Norway. Tel: +47 400 05 195.

Home
Products
Services
- Design Services
- Partners
Applications
Technologies
- Protocols
- Technology Features
News
Resources
Support
About
Distributors
Contact

Change text from Agreement option in Settings

Search Knowledgebase