EX compliance components are sometimes required by costumer for end product operation in potentially explosive environment. For details please see:
http://en.wikipedia.org/wiki/ATEX_directive
Last Update: August 8, 2017
January 25, 2017
2075
RC232 Q&A Related Knowledge Base Posts -
- [RC232] Can two gateways communicate with each other?
- [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “
- [RC232] When a packet is transmitted from one module to another, what is the receiving module going to output on its UART? The exact number of bytes sent? Or will it add some extra information like “Byte count, sender address or CRC”?
