[RC232] Do you have any application note about using modules in a RS485 bus? Application note for using the RS485 bus in not available. Last Update: August 8, 2017 February 3, 2017 1873 RC232 Q&A Related Knowledge Base Posts -[RC232] When a packet is transmitted from one module to another, what is the receiving module going to output on its UART? The exact number of bytes sent? Or will it add some extra information like “Byte count, sender address or CRC”?[RC232] “We enable the RTS/CTS option in the DK and we send message longer than 128 bytes (the max buffer size) so we need the CTS to separated the massage. We test this with scope: 1. In the CTS we didn’t see change (I suppose all 128 bytes it needs to change) 2. Also in the Tx/Rx I suppose to see a break in the 128 bytes, but it takes all the massage 3. When I try connect this module to PC, only message shorter than 1024 bytes success to send “[RC232] Are the Settings made during Configuration persistent, or do these settings need to be made each time the device is powered on ?