[ZNM] I’ve been going through your datasheet of the RC2300-ZNM module. I guess that your are using the TI CC2430 under the hood. Two MCU’s for an on/off switch sounds expensive. Isn’t it possible to bind IO of RC2300-ZNM module to a specific configured application endpoint on the same module?

“Yes, you could use only one controller (the 8051) but then you have to acquire compiler for that, a programmer and
read all the header files and compile the FW yourselves. The ZNM- module can not operate stand-alone.

So its really a tradeoff between unit cost and development cost+ time.”

Last Update: September 14, 2017