Remote factory reset is not supported by the RC232 protocol, and must be handled by host controller.
Last Update: August 8, 2017
February 3, 2017 2784 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] “I have problem to wake up RS1240 from sleep mode, in fact I can’t wake it up at all. According to documentation, config pin should be asserted when going to sleep mode, and then positive edge should wake ip module This is code I use: Config Portd.3 = Output : Modem_config Alias Portd.3 Modem_config = 1 ‘ ———— PUT MODEM IN SLEEP MODE Modem_config = 0 ‘ Assert Config pin Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ Goto SLEEP mode . . . Sub Send_packet Modem_config = 1 ‘ Wake up form SLEEP mode Waitms 60 ‘ Wait 60 ms to get out from sleep mode Print “”X””; ‘ Goto idle mode Led_tx = 1 Printbin Paket_start Printbin Data_packet Led_tx = 0 Modem_config = 0 ‘ Assert Config PIN Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ SLEEP mode End Sub But, module stuck in sleep mode, and dont send enything. When I comment all lines regarding sleep mode, module work fine. Where I’m wrong? I should deliver device this week, and this is only problem I have to resolve. “
- [RC232] Why is RC1280HP-RC232 shown as ‘Not recommended for new designs’? How much longer will be in production?
- [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “