Yes, you are allowed to transmit 500 mW at 868 Mhz in EU as long as you select your channels inside the high power sub-band (869.4 – 869.65 MHz) and use less than 10% duty-cycles.
Last Update: August 8, 2017
January 25, 2017
1097
RC232 Q&A Related Knowledge Base Posts - [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “ [RC232] For a limited space – is there any antenna that you could recommend? Preferably not longer than 3 cm. [RC232] I’d like to receive the thermal profiling for the reflow oven regarding your RC1180 and RC1701 modules. I’m looking in your website, but I can’t find this info.
