All the MBUS3 and MBUS4 products are supporting repeater (single-hop) functionality.
Last Update: August 8, 2017
February 22, 2017 2177 Wireless M-Bus Q&A
Related Knowledge Base Posts -
- [W-MBUS] As far as the data format is concerned, the “”MBUS-CCT user manual”” states: “”To send ASCII characters, type them in and hit the enter key or click on the send once button””. In case bytes have to be sent, we know that te first byte should be the Length byte. We tried to transmit the same bytes sequence shown as an example in the user manual (pag. 4): ‘5 0x33 0x25 6 78 7’. In both cases (ASCII and bytes transmission) nothing is transmitted across the link (or at least nothing appears at the receiver side). Comments?
- [W-MBUS] “I have a RC1180-MBUS3 and I want to read an encryption key in the register 1, registered with the ‘K’ command. Is it possible? How I can do that ? “
- [W-MBUS] “The WM-Bus module on my PoC unit sometimes stops sending serial messages (eg overnight). The Radiocrafts Demo PCB continues to receive OK, so it’s not the radio signal stopping, it’s the module serial output stopping. It starts again after turning Vdd off and on. This could be radio interference on the PCB wires perhaps, eg insufficient filtering on the serial data wires or Vdd wire, so I will improve that on the PCBA. “