No. They are not compatible.
Last Update: August 8, 2017
July 7, 2017 2230 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] The Datasheet for RC2500HP-RC232, shows 2 pins: PA_EN & LNA_EN, are they to be used or should I disregard them?
- [RC232] How do I bring the device in config mode without pressing the on board button?
- [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “