The fooprint and the software is exactly the same on these modules.
Last Update: November 9, 2017
November 9, 2017 3702 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] we use your Radiocrafts Modules (1180-RC232) and have problems with the configuration. Could you send us an example in C how to handle this?
- [RC232] 1. How does the RC1180-RC232 react as the supply voltage reduces below the minimum operating voltage and below – the system is powered by a Solar cell secondary cell to hold charge short to medium term. It is possible the secondary cell will start to discharge beyond the requirement for operation – does the module need to be unpowered to protect it from brown-out situations.
- [RC232] “We are drawing a new board which used your module RC1180. We are in a final phase. For the interface with the our µC, we connected only the pins : – RxD & TxD for module configuration and normal use for communication – Pin Reset, Pin 19, Pin 20 : for future programming (case of firmware update) Also, we connected the pin Vcc and ground with recommandations described in your data sheet. I would like to know, if we can use functions of test carrier transmit, modulation transmit and permanent receipt with only the pins RxD and TxD (RTS, CTS and config not connected to our µC but available on test pads). Do you have a procedure to put this module in test mode. For a firmware upgrade, could you confirm us that we need only Pin 19, 20 and reset ? “