You can factory reset the module by sending ‘@RC’ to the module while CONFIG is low.
Last Update: November 9, 2017
November 9, 2017 1241 General FAQ
Related Knowledge Base Posts -
- [General] I need info about the possible range when using higher data rates
- [General] “I have a question regarding the coexistence of your 900MHzISM radios such as RC1081 with GSM. A GSM transmitter emits 33 dBm but your maximum allowed input power is 10 dBm. Does this translate into the rather demanding requirement of minimum 23dB antenna isolation? What is the effect of having above 10dBm fed into transceiver, will the receiver only be temporarily saturated or is there a risk of permanent damage. What is the maximum allowed level to avoid permanent damage. A second question regarding interferers. As I read your datasheet a blocking interferer can be allowed to be -106dBm+3(level above sensitivity limit)+75(stated typ interferer rejection)=-28dBm. Am I interpretating your figures correctly? “
- [GENERAL] We are currently laying out our PCB to use your RC1180-RC232 and ask if there are any preferred methods that you could advise, to ensure we obtain immunity to 8KV ESD signals, especially when applied to the ground side of the antenna connection. The unit also connects to a standard USB computer port.