| The RC1780HP-TM does not connect with RC1180HP-TM of any revision – the RF link is different |
Last Update: September 22, 2017
September 22, 2017 2121 Tinymesh Q&A
Related Knowledge Base Posts -
- [TINYMESH] We are planning to power the device directly from 13Ah (or more) primary battery. Its nominal voltage in 3,6V (and open circuit 3.67V). Proposed type of the radiocrafts is RC1701HP-TM / RC1180HP-TM. The absolute maximum ratings of the RC are 3.9V. So I suppose there will be no problem?
- [TINYMESH] “We have a doubt about the connections dynamic and network architecture. Consider the image below: 1 – Gateway, Router and End device ar configured with the same RF Power 2 – Gateway signal can reach directly to End Device 3 – Router can reach to Gateway and End Device 4 – The End Device only can reach the Router when transmitting, but receive the signal from Gateway directly Although the end device can receive the signal from the Gateway (above RSSI acceptance level), once the End Device can’t reach the Gateway directly, the connection is never established and the second way through Router is never choosed. The tiny mesh algorithm favors the shortly way to gateway if the rssi level is above acceptance level. If the end device receive the signal from Gateway above acceptance level, but is not able to reach the gateway directly, even if we have a router between Gateway and End Device the connection is never establish. Do you have any explanation to this behavior and a way to improve and avoid this kind of scenario? “
- [TINYMESH] What is “link budget” of a Tinymesh module?