Yes, any module can be used with the USB-stick. Your naming is correct.
Last Update: September 14, 2017
September 14, 2017 1012 General FAQ
Related Knowledge Base Posts -
- [GEN] The signals should be injected into the SMA connector directly with a cable without using the antenna. So I would like to kindly ask if there is an upper limit to the maximum input power at the SMA connector which shouldn’t be exceeded in order to avoid possible damages to the receiving circuits?
- [GENERAL] “. I can’t connect to it via serial port. I suppose that some configuration option in memory is set incorrectly. I would like to restore the memory values to default values, so the module will hopefully respond again. My question: How do I do this? “
- [GENERAL] “We were testing the range of RC1700HP and we were able to reach about 500 or 600m (NLOS) which is far away from 1.5km you write on your web page. We used this configuration: – VCC_P was 3V3, so the TX power was 24 dBm – H169-SMA antennas on both sides (1/4 wave) – Channel 2a, 2.4kbps data rate, frame format A Please, could you give as some suggestions for increasing the range? Even if the receiver sensitivity should be -119 dBm, the lowest signal received during our test was -105dBm (reported by the module). Does it mean that the noise floor is about this value? “