[TINYMESH] Is there a way to see the hop path in the Tinymesh network? Yes, you may use the Get Path Command. Refer to the Data Sheet for details. Last Update: August 8, 2017 December 21, 2016 1361 Tinymesh Q&A Related Knowledge Base Posts -[TINYMESH] We are planning to power the device directly from 13Ah (or more) primary battery. Its nominal voltage in 3,6V (and open circuit 3.67V). Proposed type of the radiocrafts is RC1701HP-TM / RC1180HP-TM. The absolute maximum ratings of the RC are 3.9V. So I suppose there will be no problem?[TINYMESH] I have a query regarding the tiny mesh 868MHz module. Due to the restricted dimensions of the enclosure we would like to use the radiocrafts module in, is it possible to orientate the antennas of the gateway and routers in the network horizontally? Ideally to minimize system cost, would having a length of wire (at the 1/4 wavelength of 868MHz) soldered to the RF o/p of the module which would be perpendicular to the PCB give good range?[TINYMESH] Can we add an external Power Amplifier to the Tinymesh module to increase the transmission power?