Yes, we are able to provide costumer specific adjustments to the standard RC232 embedded protocol. Price and delivery time will depend on complicity and volume order.
Last Update: August 8, 2017
December 13, 2016 1618 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] Can you please confirm the width of the PCB trace from the RF pin of the RC1140-RC232 to the copper pad we use to connect a wire antenna in order to achieve 50 ohms Z0? We’ve also done the layout so the power plane has a cutout below the microstrip.
- [RC232] What is the Tx current if I change the Output power?
- [RC232] “I have problem to wake up RS1240 from sleep mode, in fact I can’t wake it up at all. According to documentation, config pin should be asserted when going to sleep mode, and then positive edge should wake ip module This is code I use: Config Portd.3 = Output : Modem_config Alias Portd.3 Modem_config = 1 ‘ ———— PUT MODEM IN SLEEP MODE Modem_config = 0 ‘ Assert Config pin Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ Goto SLEEP mode . . . Sub Send_packet Modem_config = 1 ‘ Wake up form SLEEP mode Waitms 60 ‘ Wait 60 ms to get out from sleep mode Print “”X””; ‘ Goto idle mode Led_tx = 1 Printbin Paket_start Printbin Data_packet Led_tx = 0 Modem_config = 0 ‘ Assert Config PIN Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ SLEEP mode End Sub But, module stuck in sleep mode, and dont send enything. When I comment all lines regarding sleep mode, module work fine. Where I’m wrong? I should deliver device this week, and this is only problem I have to resolve. “