[RC232] Can you please suggest us how to read the set value of PWM? I’m afraid there is no command specified to read the current PWM value. Last Update: August 8, 2017 December 13, 2016 1849 RC232 Q&A Related Knowledge Base Posts -[RC232] “I have a question for the RC2500HP-RC232, which seems not to be listed in the datasheet. We have the RC2500HP-RC232 connected to a supply voltage of 3.3v. Which voltage will the uart tx output from the RC2500HP-RC232 be? We found a other note on your site, that suggested that it would only have 2.7v on the uart tx pin, even though the module was supplied with 3.3v. “[RC232] How long does it take for the module to be active after an RF baud rate channel + reset?[RC232] The evaluation it RCxxxxHPDK-USB have a config. button – does it means that when try to configure the device need to assert it LOW ? Do you have a programmable version that can be used to assert the config pin to LOW when needed ?