[RC232] Can you please suggest us how to read the set value of PWM? I’m afraid there is no command specified to read the current PWM value. Last Update: August 8, 2017 December 13, 2016 2620 RC232 Q&A Related Knowledge Base Posts -[RC232] “We use the RC1280HP would like to know if an LNA could help improving the Rx signal of the RC1280HP. Could you give us some advice on that? “[RC232] “I bought the RC1180RC232DK (USB). Need quickly connect both modules to RS232 lines, to made a wireless path between angle-sensor and test PC. The actuator should only send each packet (packet of 4×8 bit angle values) to connected PC. Always active after power-up. Is enough to disconnect the jumpers from/to Rx/Tx lines and connect the module direct to RS232 level shifter? (inverted?) “[RC232] When a packet is transmitted from one module to another, what is the receiving module going to output on its UART? The exact number of bytes sent? Or will it add some extra information like “Byte count, sender address or CRC”?