[RC232] How can I send a pulse from the module?

Our RC232 RF protocol embedded on  the modules are using a UART interface to communicate to an external MCU. Our modules do not have a pulse input that will trigger the transmitter and if this is your request you need to do this in an external MCU. This external MCU can have a pulse input and send a byte over UART to the module. On the RX side the module will receive the byte and send it over UART to an external MCU. This MCU then output the requested pulse

    Last Update: August 8, 2017  

    December 20, 2016   1572    RC232 Q&A