RSSI is appended at the end of the packet. It may vary due to different RSSI readout for each packet.
Last Update: August 8, 2017
December 20, 2016 1702 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] When I connect RXEN and TXEN to VDD, instead of leaving open, the current consumption increases to 20, mA. When I send a character to the module over RS232, the current appears to be 134mA.
- [RC232] In order to save costs, the customer need to make a only one board that can accept the different devices: RC1240 or RC1701 / RC1701HP or RC1740 / RC1740HP or RC1780 / RC1780HP or RC11x. Could you supply a final schematic for all pins (series resistors, pull-up, diode etc.)?
- [RC232] “I have problem to wake up RS1240 from sleep mode, in fact I can’t wake it up at all. According to documentation, config pin should be asserted when going to sleep mode, and then positive edge should wake ip module This is code I use: Config Portd.3 = Output : Modem_config Alias Portd.3 Modem_config = 1 ‘ ———— PUT MODEM IN SLEEP MODE Modem_config = 0 ‘ Assert Config pin Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ Goto SLEEP mode . . . Sub Send_packet Modem_config = 1 ‘ Wake up form SLEEP mode Waitms 60 ‘ Wait 60 ms to get out from sleep mode Print “”X””; ‘ Goto idle mode Led_tx = 1 Printbin Paket_start Printbin Data_packet Led_tx = 0 Modem_config = 0 ‘ Assert Config PIN Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ SLEEP mode End Sub But, module stuck in sleep mode, and dont send enything. When I comment all lines regarding sleep mode, module work fine. Where I’m wrong? I should deliver device this week, and this is only problem I have to resolve. “