[RC232] In your schematic i can see four connections on the RF Antenna port, A66 0 Ohm Resistor to a LGA Pad, L-Bead to Connector P6, Resistor to UFL Connector P3 ,Resistor to hole. Which of them are necessary for the antenna?

The chosen antenna is selected by soldering in the 0 ohm towards this antenna, the other serial components are then Do not mount. In general, use a shunt and a series element at the output of the RF-pin towards antenna, to allow for slight impedance tuning if required. Add zero ohm towards each antenna if you want to have several options for antennas.

    Last Update: August 8, 2017  

    January 25, 2017   1743    RC232 Q&A