[TINYMESH] Should I drive any “sleep” pin to save power (The sleep pin with RC232 is noted as “reserved” when tiny mesh firmware is loaded) with tinymesh or does the MAClayer already handles any idle or power down conditions?

“Sleep mode; This is implemented in the firmware revision you will receive. You assert config-pin low, then send ‘Z’ with config still asserted low, then pull config-pin high again to release from sleep mode. Config must be pulled active high as the
internal pullup is disabled during sleep. ”

    Last Update: November 8, 2017  

    November 8, 2017   402  

    Related Knowledge Base Posts -

    No related posts found !