[W-MBUS] “I were unable to made RC1180-MBUS3 modules work in REPEATER mode using T frames. I have programmed the module following the User Manual procedure, show below NETWORK_ROLE = 0x002 MBUS_MODE = 0x001 Using the “”M”” command to record the non volatile memory. But it doesn’t work. “

Your Repeater configuration looks OK. Note that the Repeater only repeat valid SND-NR and SND-IR messages that has Hop-Cout set to 0. The Hop counter will be incremented to 1 on the repeated message. For details please see MBUS User Manual page 35.

    Last Update: September 14, 2017  

    September 14, 2017   1762    Wireless M-Bus Q&A  

    Related Knowledge Base Posts -