RC1160-MBUS3 and RC1160-MPC1 is made for compliance with Russian regulations.
Last Update: August 8, 2017
December 13, 2016 2628 Wireless M-Bus Q&A
Related Knowledge Base Posts -
- [W-MBUS] How many times can I write a KEY to the MPC1
- [W-MBUS] “How can I make a mobile readout device with RC1180-MBUS3 (…reading heat meters from car or by walking)? How can I setup up a module? Must I use „install mode=accept all”, or should I every time before I want to collect data from heat meters use The install mode, after install mode master keys settings…? “
- [W-MBUS] “I configured the MBUS radio to use the UART flow control using the CTS/RTS pins. When the host processor wants to send an MBUS message, it pulls the RTS pin low and waits for the radio to pull CTS up. The processor then sends the message. But this gives strange results, and sometimes it just fails to send the message. I also tried using only the CTS pin, where I wait for the pin to go high before sending the message. Again, this does not always work. Are the CTS/RTS pins exclusively for controlling the flow over the uart connection (host processor to radio) or are they meant to indicate when the radio can send another message ? If so, how should I use them ? “