Half liter pulse is default. This is feasible in a FW change.
Last Update: September 14, 2017
September 14, 2017 1971 Wireless M-Bus Q&A
Related Knowledge Base Posts -
- [W-MBUS] What is the standard output power of the module? Can they increase the output power ? How
- [W-MBUS] “We did configure one module in Sniffer mode and the other one in continuous data packet transmission. Whatever the transmission mode selected ( T2 or T1) the sniffer sees datapackets in 06 mode meaning T2 configuration. “
- [W-MBUS] “I configured the MBUS radio to use the UART flow control using the CTS/RTS pins. When the host processor wants to send an MBUS message, it pulls the RTS pin low and waits for the radio to pull CTS up. The processor then sends the message. But this gives strange results, and sometimes it just fails to send the message. I also tried using only the CTS pin, where I wait for the pin to go high before sending the message. Again, this does not always work. Are the CTS/RTS pins exclusively for controlling the flow over the uart connection (host processor to radio) or are they meant to indicate when the radio can send another message ? If so, how should I use them ? “