Yes, the sniffer should show all communication between the units
Last Update: August 8, 2017
July 21, 2017 2213 ZNM Q&A
Related Knowledge Base Posts -
- [ZNM] “For executing “”SYS_RESET_REQ”” command, I’ve processed as follows; set “”MRDY and SS”” to “”low”” & check the status of “”SRDY”” to “”low”” -> in host processor, sent “”SYS_RESET_REQ”” command -> waited the result of “”SDRY”” to “”high””, but not appeared “
- [ZNM] “We use the Zigbee Network module RC241x/RC241xHP and we would like to know if this devices are ESD sensible. Can you give us the ESD sensibility? ‘”
- [ZNM] “We have started a design with TI’s ZNP solution (CC2530). We where also interested in adding the PA/LNA chip (CC2591) for extended range. Based on what I found on the web, this is the same architecture you use in your RC2400HP-ZNM module. I like this module because it’s very compact. My first question would be if we can use the ZNP version of the stack with this? I would guess so, but a confirmation would be appreciated. I’m interested to do a comparison between building our own PCB with TI parts or simply integrate your module. “