[TINYMESH] data needs to be received without delay Latency is typically in the range of fractions of a second. Last Update: November 9, 2017 November 9, 2017 1410 Tinymesh Q&A Related Knowledge Base Posts -[TINYMESH] CTS pin is recommended to be observed before UART is driven on a byte by byte basis in tinymesh documents. Some other paragraph tells as if it is unnecessary and only two pins are enough. How critical is that issue?[TINYMESH] For compliance testing, does Tinymesh provide a test mode with “continuous transmission with 100% duty cycle?[TINYMESH] In the datasheet it says RTS signal may block the GWAY if held high too long. How long is that duration?