EX compliance components are sometimes required by costumer for end product operation in potentially explosive environment. For details please see:
http://en.wikipedia.org/wiki/ATEX_directive
Last Update: August 8, 2017
January 25, 2017 2268 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] What is the maximum output power for RC1190-RC232 in 900MHz band, 5dBm or 9dBm?
- [RC232] “I have problem to wake up RS1240 from sleep mode, in fact I can’t wake it up at all. According to documentation, config pin should be asserted when going to sleep mode, and then positive edge should wake ip module This is code I use: Config Portd.3 = Output : Modem_config Alias Portd.3 Modem_config = 1 ‘ ———— PUT MODEM IN SLEEP MODE Modem_config = 0 ‘ Assert Config pin Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ Goto SLEEP mode . . . Sub Send_packet Modem_config = 1 ‘ Wake up form SLEEP mode Waitms 60 ‘ Wait 60 ms to get out from sleep mode Print “”X””; ‘ Goto idle mode Led_tx = 1 Printbin Paket_start Printbin Data_packet Led_tx = 0 Modem_config = 0 ‘ Assert Config PIN Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ SLEEP mode End Sub But, module stuck in sleep mode, and dont send enything. When I comment all lines regarding sleep mode, module work fine. Where I’m wrong? I should deliver device this week, and this is only problem I have to resolve. “
- [RC232] I’m not currently using flow control, and am having an issue in correctly identifying the start of each 64 byte packet. My understanding of CTR/RTS is that they wouldn’t help in this? Is there a signal that shows the start of each packet?