[GENERAL] “. I can’t connect to it via serial port. I suppose that some configuration option in memory is set incorrectly. I would like to restore the memory values to default values, so the module will hopefully respond again. My question: How do I do this? “

“There are two ways to fix corrupt settings in memory.
– Write new configuration to memory via UART Or
– Reflash module

Do you receive any character on the UART, when you press the Config button?
If you receive anything else than a ‘>’ the UART rate is probably off.
For such case a different UART setting might work.

If you do not receive any character when pressing Config button the board must be re-flashed.”

Last Update: November 9, 2017