[RC232] “Please confirm that: RC1180/1140 and 1190 have exactly the same foot print/pin out… The goal being to have only one PCB and the same print for the 3 modules. “ The fooprint and the software is exactly the same on these modules. Last Update: November 9, 2017 November 9, 2017 2249 RC232 Q&A Related Knowledge Base Posts -[RC232] “I bought the RC1180RC232DK (USB). Need quickly connect both modules to RS232 lines, to made a wireless path between angle-sensor and test PC. The actuator should only send each packet (packet of 4×8 bit angle values) to connected PC. Always active after power-up. Is enough to disconnect the jumpers from/to Rx/Tx lines and connect the module direct to RS232 level shifter? (inverted?) “[RC232] Question regarding RC232 in Star mode (many to one). If more than node will transmit at same to central point – will RC232 protocol queue data somehow, or there will be collision or data will be lost?[RC232] When I set the transmit power to the smallest value, is only the transmit power reduced or also the receive power?