It should not influence on the VCO, but the specter might be more noisy if it affect the power amp stage. If the noise is inside the channel bandwidth it will influence on receiver performance.
Last Update: August 8, 2017
December 20, 2016 1707 RC232 Q&A
Related Knowledge Base Posts -
- [RC232] Each slave boat will have a bit rate of 1Kbps to the master node, the signal range must be till 2km (line of sight). We are considering using RC17xxHP-RC232 modules to communicate with master boat and slaves. It’s possible with this device to create a multipoint network (one master, many slaves)?
- [RC232] “I bought the RC1180RC232DK (USB). Need quickly connect both modules to RS232 lines, to made a wireless path between angle-sensor and test PC. The actuator should only send each packet (packet of 4×8 bit angle values) to connected PC. Always active after power-up. Is enough to disconnect the jumpers from/to Rx/Tx lines and connect the module direct to RS232 level shifter? (inverted?) “
- [RC232] “I have problem to wake up RS1240 from sleep mode, in fact I can’t wake it up at all. According to documentation, config pin should be asserted when going to sleep mode, and then positive edge should wake ip module This is code I use: Config Portd.3 = Output : Modem_config Alias Portd.3 Modem_config = 1 ‘ ———— PUT MODEM IN SLEEP MODE Modem_config = 0 ‘ Assert Config pin Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ Goto SLEEP mode . . . Sub Send_packet Modem_config = 1 ‘ Wake up form SLEEP mode Waitms 60 ‘ Wait 60 ms to get out from sleep mode Print “”X””; ‘ Goto idle mode Led_tx = 1 Printbin Paket_start Printbin Data_packet Led_tx = 0 Modem_config = 0 ‘ Assert Config PIN Waitms 5 ‘ MAX Time from CONFIG pin is set low until prompt (“”>””) Print “”Z””; ‘ SLEEP mode End Sub But, module stuck in sleep mode, and dont send enything. When I comment all lines regarding sleep mode, module work fine. Where I’m wrong? I should deliver device this week, and this is only problem I have to resolve. “