[GENERAL] “Now my next step is to configure the module on the pc board. Can I use the Usb Stick OR Must I send it via the UART from my microcontroller. I obviously have to pull the config pin low. “

“For the module on the PC board you might maybe have to configure it via the microcontroller. If you have access to the modules UART you could also connect cables from the demo kit (if you have one of our
USB demo kits) to the UART so you can connect it to a COM-port and then use the CCT tool for changing the config memory. You are right, you must assert the config pin low and check for the prompt “>” before
sending the command-sequence. Remember to end with 0xFF and then exit via ‘X’.

    Last Update: January 18, 2018  

    January 18, 2018   804    General FAQ