[RIIM] When setting up the Mesh, will the network show on a mobile device, laptop for example? Or not? Or is the private network invisible for other devices?
[RIIM] What is the minimum distance between two nodes? Can they be placed right next to each other, or will the signal be too strong for the neighbor?
[RIIM] What is the battery capacity needed for a leaf node, given a 10 byte payload / transmits every minute / 5 year lifetime?
[RIIM] The sleeping leaf node current consumption is stated to be ~5uA/25uA for standard and high power modules. Does this include the RF activity required by radio protocol, and if yes, at which power level is TX operating?
[RIIM] Please describe the steps that are happening when a new node is introduced in a RIIM network and how that will know the address.
[RIIM] Is there an acknowledgement (ACK) from the sensor in order to know if the data has been transmitted correctly?
[RIIM] In case the customer needs to have a backup gateway, can RIIM be operated with two gateways or more gateways in one network?
[RIIM] In case I want to use a RIIM Over-The-Air Download (OAD) to update an external MCU, how is the process done ?
[RIIM] If there is a way to get the clock from the module, in addition to when i am storing measured data, can I take the Timestamp on each measurement?
[RIIM] If one node in the network is un-powered (like when I change battery), how long time will it be until it joins the network again when powered?
[RIIM] How long will the Rx/Tx current be active on a Leaf node from wake up, to sending 10 bytes, until it goes back to sleep?
[RIIM] How does the dashboard work and build the network map? Does it represent how the network looks like in the field?
[RIIM] How do the Over-The-Air Downloads (OAD) work in real life? What happens if I use multiple firmware SW modules in the field, how do i manage the OAD so that a specific end unit gets the correct image. can we choose to update a specific end node (IP address)?
[RIIM] Do you need a programmer to program the devices? I suppose the development boards can be programmed with the USB?
[RIIM] Can I use a Ping to check the connection to a Router node? And can I use Ping to check connection to an End Device?
[RIIM] Can I send a message directly from one node to another node in the network, without the message being routed through the Border router?
[RIIM] Can I save values to the EEPROM, will it wear out? Or can I store values in any other way in the event of power loss?
[RIIM] Can I force the mesh structure to route data in a certain path? I.e, can I force a static mesh structure?
