No, we do not provide the source code for Tinymesh protocol.
Last Update: August 8, 2017
December 21, 2016 1828 Tinymesh Q&A
Related Knowledge Base Posts -
- [TINYMESH] What application layers are supported by Tinymesh?
- [TINYMESH] CTS pin is recommended to be observed before UART is driven on a byte by byte basis in tinymesh documents. Some other paragraph tells as if it is unnecessary and only two pins are enough. How critical is that issue?
- [TINYMESH] “We have a doubt about the connections dynamic and network architecture. Consider the image below: 1 – Gateway, Router and End device ar configured with the same RF Power 2 – Gateway signal can reach directly to End Device 3 – Router can reach to Gateway and End Device 4 – The End Device only can reach the Router when transmitting, but receive the signal from Gateway directly Although the end device can receive the signal from the Gateway (above RSSI acceptance level), once the End Device can’t reach the Gateway directly, the connection is never established and the second way through Router is never choosed. The tiny mesh algorithm favors the shortly way to gateway if the rssi level is above acceptance level. If the end device receive the signal from Gateway above acceptance level, but is not able to reach the gateway directly, even if we have a router between Gateway and End Device the connection is never establish. Do you have any explanation to this behavior and a way to improve and avoid this kind of scenario? “